Edge-Core ECS4610-24F Installation Guide Page 72
- Page / 92
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
C
HAPTER
B
| Cables
Twisted-Pair Cable and Pin Assignments
– 72 –
10BASE-T/100BASE-TX PIN ASSIGNMENTS
Use unshielded twisted-pair (UTP) or shielded twisted-pair (STP) cable for RJ-45
connections: 100-ohm Category 3 or better cable for 10 Mbps connections, or
100-ohm Category 5 or better cable for 100 Mbps connections. Also be sure
that
the length of any twisted-pair connection does not exceed 100 meters (328 feet).
The RJ-45 ports on the switch base unit support automatic MDI/MDI-X
operation, so you can use straight-through cables for all network connections to
PCs or servers, or to other switches or hubs. In straight-through cable, pins 1, 2,
3, and 6, at one end of the cable, are connected straight through to pins 1, 2, 3,
and 6 at the other end of the cable. When using any RJ-45 port on this switch,
you can use either straight-through or crossover cable.
Note:The “+” and “-” signs represent the polarity of the wires that
make up each wire pair.
STRAIGHT-THROUGH WIRING
If the twisted-pair cable is to join two ports and only one of the ports has an
internal crossover (MDI-X), the two pairs of wires must be straight-through.
(When auto-negotiation is enabled for any RJ-45 port on this switch, you can
use either straight-through or crossover cable to connect to any device type.)
You must connect all four wire pairs as shown in the following diagram to
support Gigabit Ethernet.
Table 17: 10/100BASE-TX MDI and MDI-X Port Pinouts
Pin MDI Signal Name MDI-X Signal Name
1 Transmit Data plus (TD+) Receive Data plus (RD+)
2 Transmit Data minus (TD-) Receive Data minus (RD-)
3 Receive Data plus (RD+) Transmit Data plus (TD+)
6 Receive Data minus (RD-) Transmit Data minus (TD-)
4,5,7,8 Not used Not used
- NSTALLATION 3
- COMPLIANCES AND SAFETY 5
- STATEMENTS 5
- SAFETY COMPLIANCE 7
- PSE ALARM 7
- POWER CORD SAFETY 8
- OMPLIANCES 10
- TATEMENTS 10
- ENVIRONMENTAL STATEMENTS 12
- END OF PRODUCT LIFE SPAN 13
- MANUFACTURING MATERIALS 13
- DOCUMENTATION 13
- – 14 – 14
- ABOUT THIS GUIDE 15
- REVISION HISTORY 16
- CONTENTS 17
- – 18 – 18
- – 19 – 19
- – 20 – 20
- – 21 – 21
- – 22 – 22
- 1 INTRODUCTION 23
- SWITCH ARCHITECTURE 24
- DESCRIPTION OF HARDWARE 25
- STACKING PORTS 26
- PORT AND SYSTEM STATUS LEDS 26
- System Status LEDs 27
- POWER SUPPLY SOCKET 28
- Power Socket 28
- Redundant Power Socket 28
- 10GBASE XFP MODULE 29
- EXTENDER MODULE LEDS 29
- FEATURES AND BENEFITS 30
- MANAGEMENT 31
- 32
- Features and Benefits 32
- – 32 – 32
- 2 NETWORK PLANNING 33
- APPLICATION EXAMPLES 34
- 10/100/1000 Mbps Segments 35
- 36
- Application Examples 36
- – 36 – 36
- MAKING VLAN CONNECTIONS 37
- USING LAYER 3 ROUTING 38
- APPLICATION NOTES 39
- Application Notes 40
- – 40 – 40
- 3 INSTALLING THE SWITCH 41
- ETHERNET CABLING 42
- RJ-45 Connector 42
- EQUIPMENT CHECKLIST 43
- MOUNTING 44
- 45
- Mounting 45
- – 45 – 45
- ESKTOP OR SHELF MOUNTING 46
- – 47 – 47
- 48
- – 48 – 48
- ONNECTING SWITCHES IN A STACK 49
- STACKING TOPOLOGIES 50
- CONNECTING TO A POWER SOURCE 51
- WIRING MAP FOR SERIAL CABLE 52
- – 53 – 53
- – 54 – 54
- 4 MAKING NETWORK CONNECTIONS 55
- Twisted-Pair Devices 56
- – 56 – 56
- NETWORK WIRING CONNECTIONS 57
- IBER OPTIC SFP DEVICES 58
- 59
- Fiber Optic SFP Devices 59
- – 59 – 59
- – 60 – 60
- BPS FIBER OPTIC CONNECTIONS 61
- – 62 – 62
- CONNECTIVITY RULES 63
- BPS ETHERNET COLLISION DOMAIN 65
- – 66 – 66
- A TROUBLESHOOTING 67
- POWER AND COOLING PROBLEMS 69
- INSTALLATION 69
- IN-BAND ACCESS 69
- STACK TROUBLESHOOTING 70
- B CABLES 71
- STRAIGHT-THROUGH WIRING 72
- CROSSOVER WIRING 73
- 1000BASE-T PIN ASSIGNMENTS 74
- FIBER STANDARDS 75
- C SPECIFICATIONS 77
- 78
- Physical Characteristics 78
- – 78 – 78
- SWITCH FEATURES 79
- MANAGEMENT FEATURES 80
- STANDARDS 80
- COMPLIANCES 81
- 10GBASE EXTENDER MODULE (XFP) 81
- NETWORK INTERFACE 82
- GLOSSARY 83
- – 84 – 84
- – 85 – 85
- – 86 – 86
- – 87 – 87
- – 88 – 88
- ECS4610-26T 92
- ECS4610-50T 92
- E052010-MW-R01 92
- 150200000149A 92
Related products and manuals for Network switches Edge-Core ECS4610-24F
(64 pages)
(32 pages)
(24 pages)© 2020, manymanuals.com. All rights reserved. | 0.263 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals